Device::PiLite This is a module to interface with the Pi-Lite device for the Raspberry PI from Ciseco. This is a self contained board based on the Lots of Leds shield for the Arduino that supports the Raspberry PI by embedding an Atmel AVR with (by default) firmware that allows the Raspberry PI to communicate with it over the GPIO serial port. This module simply encapsulates the required serial messages in order to control the board. INSTALLATION It is assumed you have installed the board and followed the instructions at: http://openmicros.org/index.php/articles/94-ciseco-product-documentation/raspberry-pi/283-setting-up-my-raspberry-pi to prepare your Raspberry PI to work with your board. The instructions are for the default Debian based OS, if you are using some other distribution I'm assuming that you know enough to do the functional equivalent. (For reference I developed this on a Fedora based dsitribution.) To install this module, run the following commands: perl Build.PL ./Build ./Build test ./Build install SUPPORT AND DOCUMENTATION After installing, you can find documentation for this module with the perldoc command. perldoc Device::PiLite You can also look for information at: RT, CPAN's request tracker (report bugs here) http://rt.cpan.org/NoAuth/Bugs.html?Dist=Device-PiLite AnnoCPAN, Annotated CPAN documentation http://annocpan.org/dist/Device-PiLite CPAN Ratings http://cpanratings.perl.org/d/Device-PiLite Search CPAN http://search.cpan.org/dist/Device-PiLite/ LICENSE AND COPYRIGHT Copyright (C) 2014 Jonathan Stowe This program is free software; you can redistribute it and/or modify it under the terms of either: the GNU General Public License as published by the Free Software Foundation; or the Artistic License. See L for more information.