Pod-InComments version 0.9 =========================== Module for embedding POD in the comments of your config file. With the appropriate routines to extract the whole or parts of it. E.g., when your config file looks like: ;=head1 cpu ; ;Specifies cpu settings for normal boxes ;note that these will override factory settings! ; ;=head2 maxload ; ;The maxload setting gives an upperbound on how hard ;the CPU can be pushed. [cpu] maxload=4.0 then doing: my $pod = $podparser->Pod4Section( 'cpu', 'maxload' ); will give you: The maxload setting gives an upperbound on how hard the CPU can be pushed. INSTALLATION To install this module type the following: perl Makefile.PL make make test make install DEPENDENCIES This module requires these other modules and libraries: Pod::POM COPYRIGHT AND LICENCE Put the correct copyright and licence information here. Copyright (C) 2007 by Jaap Voets This library is free software; you can redistribute it and/or modify it under the same terms as Perl itself, either Perl version 5.8.5 or, at your option, any later version of Perl 5 you may have available.